Where can I get the Configuration guide for SONiC

• Related Articles

• Where can I get the installation guide for SONiC

  Attached document give the steps for the installation of

• Management Interface Configuration (SONiC)

  Configure the management interface (eth0) for network administration in SONiC. Default Configuration: By default, eth0 uses DHCP to dynamically obtain an IP address from a DHCP server. Static IP Configuration: Command Line: sudo config interface ip ...

• Syslog server configuration in Broadcom SoNiC

  1. To Configure remote syslog server to forward syslog messages Command: logging server <host> [ message-type { audit | auditd-system | event | log } ] [ remote-port <vrport> ] [ protocol { tcp | tls | udp } ] [ source-interface { Ethernet | Loopback ...

• DHCP Snooping configuration on Broadcom Sonic

  Enabling DHCP Snooping Command: ip dhcp snooping This command enables DHCP Snooping globally on the device, helping monitor and block unauthorized DHCP servers. Disable DHCP snooping sonic-cli# configure terminal sonic-cli(config)# no ip dhcp ...

• Interface Configuration in SONiC

  To manage interface settings in SONiC, use the following commands. Change Interface Speed To modify the speed of an interface, use the command: sudo config interface speed <interface> <speed_in_Mbps> Example: sudo config interface speed ethernet10 ...